 |
| R32 Skyline Haltech Elite Mounting Kit |
There are clean ways to mount your aftermarket ECU, and then there is stuffing it under the carpet, and hoping no one steps on it. So far there are a few small companies in the US, that make nice ECU mounting brackets. It seems the rest of the world likes to just leave the ECU hanging, or laying, as it may be. This kit from OST Dyno mounts your Haltech ECU under the dash.
This mounting kit includes everything needed to securely mount your Haltech Elite underneath the glovebox of your R32 Skyline (should work for all models but only tested in a GTR). Elite ECU not included
Features:
Stainless steel construction
Easy installation (about 10 minutes)
Keeps ECU out of passenger footwell where it may be damaged
Provisions to keep jumper harness neat and tidy
Clears JDM road flare mount
Made in the USANote: The Series 1 (pre-August 1991) cars have a different blower motor under the dash. Of course this could have been changed to a later motor at some point in your car’s life. Please confirm what motor you have. An easy way is to look at the length of the vent hose. The Series 1 is about 6 inches and runs under the heater box while the Series 2 is only a couple inches and does not run under the heater box. If you are unsure what motor you have, the Series 1 bracket will fit both Series 1 and 2 cars. The difference is that the Series 2 bracket tucks the ECU up higher due to the smaller blower motor.
.jpg)
No comments:
Post a Comment